Mirrors: Service and Repair
REMOVAL
1. REMOVE INSIDE HANDLE BEZEL
a. Using a screwdriver, open the screw cap.
HINT: Tape the screwdriver tip before use.
b. Remove the screw.
c. Using a screwdriver, remove the inside handle bezel as shown in the illustration.
HINT: Tape the screwdriver tip before use.
2. REMOVE POWER WINDOW SWITCH
a. Using a screwdriver, remove the power window switch.
HINT: Tape the screwdriver tip before use.
b. Disconnect the connectors.
3. REMOVE FRONT ARMREST
a. Remove the screw.
b. Using a screwdriver, remove the front armrest as shown in the illustration.
HINT: Tape the screwdriver tip before use.
4. REMOVE LOWER FRAME BRACKET GARNISH
Remove the lower frame bracket garnish.
5. REMOVE DOOR TRIM
a. Using a screwdriver, remove the courtesy light, then disconnect the connector.
HINT: Tape the screwdriver tip before use.
b. Using a screwdriver, disengage the clips, then pull the trim upward to remove it.
HINT: Tape the screwdriver tip before use.
6. REMOVE FRONT NO. 2 SPEAKER
a. Disconnect the connector.
b. Remove the 2 bolts and front No. 2 speaker.
7. REMOVE OUTSIDE REAR VIEW MIRROR
a. Disconnect the connector.
b. Remove the bolt and outside rear view mirror.
REPLACEMENT
1. IF NECESSARY, DISCONNECT MIRROR
a. Insert a shop rag between the mirror and the mirror body.
b. Pull up the lower side of the shop rag to disconnect the mirror joint.
c. Pull up the mirror and disconnect it.
d. Disconnect the connectors.
2. CONNECT MIRROR
a. Connect the connectors.
b. Connect the claws (A) and set the mirror to the mirror body.
c. Push the mirror to connect the claws (B) and set it.
INSTALLATION
1. INSTALL OUTSIDE REAR VIEW MIRROR
a. Install the outside rear view mirror with the bolt.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
b. Connect the connector.
2. INSTALL FRONT NO. 2 SPEAKER
a. Install the front No. 2 speaker with the 2 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
b. Connect the connector.
3. INSTALL DOOR TRIM
a. Install the door trim to the door panel.
b. Connect the connector, then install the courtesy light.
4. INSTALL LOWER FRAME BRACKET GARNISH
Install the lower frame bracket garnish to the door panel.
5. INSTALL FRONT ARMREST
Install the front armrest with the screw.
6. INSTALL POWER WINDOW SWITCH
a. Connect the connectors.
b. Install the power window switch.
7. INSTALL INSIDE HANDLE BEZEL
a. Install the inside handle bezel with the screws.
b. Close the screw cap.