Extension Housing

COMPONENTS

DISASSEMBLY





1. REMOVE EXTENSION HOUSING DUST DEFLECTOR
Using a plastic hammer, remove the dust deflector.





2. REMOVE EXTENSION HOUSING OIL SEAL
Using a screwdriver, remove the oil seal.

INSPECTION





INSPECT EXTENSION HOUSING BUSHING
Using a calipers gauge, measure the inside diameter of the extension housing bushing.

Maximum inside diameter: 40.08 mm (1.5779 in.)

If the inside diameter is greater than the maximum, replace the extension housing.

REASSEMBLY





1. INSTALL NEW EXTENSION HOUSING OIL SEAL
a. Using SST and a hammer, carefully drive a new oil seal in as far as it will go. SST 09325-20010

NOTICE: Clean the extension housing before removing the oil seal.

b. Coat the lip of a new oil seal with MP grease.





2. INSTALL NEW EXTENSION HOUSING DUST DEFLECTOR
Using SST and hammer, carefully drive a new dust deflector in as far as it will go. SST 09223-15030, 09950-70010 (09951-07100)