Climate Control Exhaust Gas Sensor: Service and Repair

SENSOR

REMOVAL




1. REMOVE SOLAR SENSOR
Using a screw driver pull out the sensor and disconnect the connector.

HINT:
- Tape the screwdriver tip before use.




- At the time of installation, please refer to the following item.
Insert the sensor to instrument panel as shown in the Illustration.

2. REMOVE ROOM TEMPERATURE SENSOR
a. Remove the No.1 under cover.




b. Remove the room temperature sensor.
1. Remove the No.1 safety pad set bolts and screws.
2. Disconnect the connector and aspirator hose.
3. Remove the screw and sensor.




3. REMOVE AMBIENT TEMPERATURE SENSOR
a. Disconnect the connector.
b. Using a clip remover, pull out the sensor from bumper reinforcement.

4. REMOVE EVAPORATOR TEMPERATURE SENSOR
a. Remove these parts:
1. No.1 undercover
2. No.1 safety pad




b. Remove the evaporator temperature sensor.
1. Using a screwdriver, pull out the sensor with bracket plate.

HINT: Tape the screwdriver tip before use.




2. Release the 2 claws and remove the sensor from bracket plate.




5. REMOVE SMOG VENTILATION SENSOR
a. Disconnect the connector.
b. Remove the bolt and sensor.

INSTALLATION
Installation is in the reverse order of removal.