Disassembly and Assembly

DISASSEMBLY
1. REMOVE DUST DEFLECTOR
Using a screwdriver, remove the dust deflector.
2. REMOVE AXLE HUB





a. Remove the 2 bolts, nuts and pin.
b. Mount the axle carrier in a vise.

HINT: Use a set of soft jaws in the vise to protect the axle carrier.

NOTICE: Do not tighten the vise too tight.





c. Using SST, remove the axle hub from the axle carrier.
SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011), 09950-60010 (09951-00480)
d. Remove the backing plate.





e. Using SST, remove the bearing inner race from the axle hub.
SST 09950-00020, 09950-40011 (09951-04020, 09953-04030, 09957-04010), 09950-50012 (09952-05010, 09954-5020, 09955-05040), 09950-60010 (09951-00480)

NOTICE: Be careful not to damage the axle hub.

3. REMOVE BEARING
a. Using snap ring pliers, remove the snap ring from the axle carrier.





b. Using SST and a press, remove the bearing from the axle carrier.
SST 09950-60010 (09951-00650), 09950-70010 (09951-07100)

REASSEMBLY





1. INSTALL BEARING
a. Using SST and a press, install a new bearing to the axle carrier.
SST 09223-15020, 09527-17011, 0995-70010 (09951-07100)
b. Using snap ring pliers, install a new snap ring to the axle carrier.
2. INSTALL AXLE HUB
a. Install the backing plate, pin, 2 bolts and nuts.
Torque: 59 Nm (600 kgf-cm, 43 ft. lbs.)





b. Using SST and a press, install the axle hub to the axle carrier.
SST 09527-17011, 09950-60020 (09551-00750), 0995-70010 (09951-07100)





3. INSTALL DUST DEFLECTOR
Using SST and a hammer, install a new dust deflector to the axle carrier.
SST 09527-17011, 09950-60020 (09951-01030), 09950-70010 (09951-07100)

HINT: Align the speed sensor installation hole of dust deflector and that of axle carrier.