Front Fender Apron (Assembly)

FRONT FENDER APRON (ASSEMBLY)

REPLACEMENT

1. REMOVE RADIATOR SUPPORT
2. REMOVE FRONT FENDER APRON







a. Leave the front fender apron rear extension to the vehicle, remove the front fender apron.

3. INSTALL FRONT FENDER APRON

HINT: Inspect the fitting of the front fender and hood, etc. before welding, since this affects the appearance of the finish.

a. Remove the front fender apron rear extension from the new parts of front fender apron.







b. Temporarily install the new parts and measure each part in accordance with the body dimension diagram.

HINT: Make sure each measurement is correct, as this parts affects the front wheel alignment.


4. MEASURING THE ENGINE COMPARTMENT DIMENSIONS
5. MEASURING THE UNDER BODY DIMENSIONS
6. INSTALL RADIATOR SUPPORT
7. APPLYING SEALER TO THE ENGINE COMPARTMENT
8. APPLYING UNDER COATING
9. APPLYING ANTI-RUST AGENT
a After applying the top coat layer, apply the anti-rust agent to the inside of the necked section structural weld spots.