Removal and Installation

Seat Position Sensor Assembly:

REMOVAL

NOTE:
- Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)
- If the wiring connector of the SRS is disconnected with the ignition switch at ON position, DTCs will be recorded.

HINT: For step 1, refer to FRONT SEAT.

1. REMOVE FRONT SEAT ASSEMBLY (DRIVER SIDE)




2. REMOVE SEAT POSITION SENSOR ASSEMBLY
a. Remove the bolt and seat position sensor assembly.
b. Disconnect the connector.

INSTALLATION

NOTE:
- Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
- Never reuse the seat position sensor assembly involved in a collision when the airbag has deployed.
- Never repair a sensor in order to reuse it.

HINT: For step 2, refer to FRONT SEAT.




1. INSTALL SEAT POSITION SENSOR ASSEMBLY
a. Connect the connector.
b. Install the seat position sensor assembly with the bolt.

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

NOTE:
- Connection of the connector is done after the sensor assembly has been installed.
- Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.

2. INSTALL FRONT SEAT ASSEMBLY