Speed Sensor, Front

REMOVAL
1. REMOVE FRONT WHEEL





2. DISCONNECT SPEED SENSOR CONNECTOR
Disconnect the connector from the speed sensor.
3. REMOVE SPEED SENSOR WITH FRONT AXLE HUB
4. REMOVE SPEED SENSOR
(a) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
SST 0952-00031





(b) Mount the front axle hub in a soft jaw vise.

NOTICE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.

(c) Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the speed sensor.
SST 0952-00031 (09520 00040, 09521-0020), 0995-00020

NOTICE:
- If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
- Do not scratch the contacting surface of axle hub and speed sensor.





5. IF NECESSARY, REPLACE SPEED SENSOR WIRE HARNESS
(a) Remove the front fender liner.
(b) Disconnect the speed sensor wire harness connector.
(c) Remove the 3 bolts holding the sensor harness from the lower arm and body.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
(d) Replace the sensor wire harness.

INSTALLATION
1. INSTALL NEW SPEED SENSOR
(a) Clean the contacting surface of the axle hub and a new speed sensor.

NOTICE: Do not stick any foreign objects to the sensor rotor.





(b) Place the speed sensor on the axle hub so that the connector will be positioned as shown in the illustration under the on-vehicle condition.





(c) Using SST and a press, install a new speed sensor to the axle hub.
SST 09214-76011

NOTICE:
- Do not tap the speed sensor with a hammer directly.
- Check that there should be no foreign objects on the speed sensor detection portion.
- Press in the speed sensor straight and slowly.

2. INSTALL SPEED SENSOR WITH FRONT AXLE
3. CONNECT SPEED SENSOR CONNECTOR
4. INSTALL FRONT FENDER LINER WHEEL
5. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. CHECK SPEED SENSOR SIGNAL