Door Lock Remote Transmitters - Programming
ELECTRICALEL005-01
August 10, 2001
Title:
PROGRAMMING WIRELESS DOOR LOCK REMOTE TRANSMITTERS
Models:
'01 LS 430 & '02 SC 430
Introduction:
This bulletin clarifies the Repair Manual procedure titled "By Switch Operation" for the programming of new or existing wireless remote transmitters for the 2001 model year LS 430 and 2002 model year SC 430.
Applicable
^ 2001 model year LS 430 vehicles.
^ 2002 model year SC 430 vehicles.
Warranty Information
Programming To Program Wireless Transmitters
Procedure
1. Begin with:
^ The driver's door open and unlocked.
^ Key out of the ignition.
2. Insert and remove the key from the ignition switch 2 times within 5 seconds.
3. Close and open the driver's door twice within 40 seconds.
4. Insert the key into the ignition and remove it.
5. Close and open the driver's door twice within 40 seconds.
6. Insert the key into the ignition.
7. Close the door.
8. Turn the ignition switch from "Lock" to "On" and back to "Lock" at about 1 second intervals to select the desired mode:.
^ 1 time for ADD mode.
^ 2 times for REWRITE mode.
^ 3 times for CONFIRMATION mode.
^ 5 times for PROHIBITION mode.
9. Remove the key from the ignition.
10. To confirm your selection of all modes except Confirmation mode, the power locks will now cycle "lock" to "unlock" a number of times corresponding to your key cycles in step 8.
A. If Confirmation mode has been selected, the power door locks will now cycle (in 2 second intervals) a number of times corresponding to the number of transmitters currently registered. Opening the door will complete the procedure.
B. If Prohibition mode has been selected, opening the door will complete the procedure.
11. For Add or Rewrite modes, within 40 seconds of Door Lock confirmation.
A. Press both transmitter Lock and Unlock buttons simultaneously between 1 and 1.5 seconds and release.
B. Within 3 seconds of step A, press the transmitter Lock button for more than 1 second and release.
C. If the transmitter has been successfully programmed, the power locks will cycle "lock" to "unlock" once at this time. If there are problems with the procedure used up to this point, the locks will cycle twice, in which case you must go back and repeat the above process.
D. If multiple remotes are to be programmed, repeat steps A-C.
12. Open the Driver's Door to complete the procedure.