Power Steering

Part 1 Of 6:

Part 2 Of 6:

Part 3 Of 6:

Part 4 Of 6:

Part 5 Of 6:

Part 6 Of 6:

REPLACEMENT
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER APRON SEAL RH





3. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Loosen the bolt A and B.
b. Loosen the adjusting bolt C, and remove the V-ribbed belt.





4. REMOVE VANE PUMP V BELT
a. Loosen the bolt A and B. and remove the V-ribbed belt.





5. INSTALL VANE PUMP V BELT
a. Install the V-ribbed belt on each pulley.
b. Using a bar, adjust the V-ribbed belt tension and tighten the bolt B.
Torque: 43 Nm (439 kgf-cm, 32 ft. lbs.)
c. Tighten the bolt A.
Torque: 43 Nm (439 kgf-cm, 32 ft. lbs.)





6. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Install the V-ribbed belt on each pulley.
b. Tighten the adjusting bolt C, and adjust the V-ribbed belt tension. First tighten the bolt A, then B.
Torque:
Bolt A 58 Nm (591 kgf-cm, 43 ft. lbs.)
Bolt B 18 Nm (184 kgf-cm, 13 ft. lbs.)
7. INSPECT DRIVE BELT DEFLECTION AND TENSION(REFERENCE)
8. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)