Pinout Values and Diagnostic Parameters
TERMINALS OF ECUTerminals Of ECU:
1. CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DRIVER'S DOOR ECU)
a. Disconnect the D17 connector.
Pinouts:
b. Check the voltage and continuity of each terminal of the wire harness side connector.
HINT: If the value is not as specified, there may be a malfunction in the wire harness side
Pinouts:
c. Connect the D17 connector, and check the voltage between each terminal of the connector.
HINT: If the value is not as specified, replace the power window regulator master switch.
Terminals Of ECU:
2. CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY (PASSENGER'S DOOR ECU)
a. Disconnect the F13 connector.
Pinouts:
b. Check the voltage and continuity of each terminal of the wire harness side connector.
HINT: If the value is not as specified, there may be a malfunction in the wire harness side.
Pinouts:
c. Connect the F13 connector, and check the voltage between each terminal of the connector.
HINT: If the value is not as specified, replace the power window regulator switch.
Terminals Of ECU:
3. CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR (LH SIDE)
a. Disconnect the R15 connector.
Pinouts:
b. Check the voltage and continuity of each terminal of the wire harness side connector.
HINT: If the value is not as specified, there may be a malfunction in the wire harness side.
Pinouts:
c. Connect the R15 connector, and check the voltage between each terminal of the connector.
HINT: If the value is not as specified, replace the power window regulator switch assembly rear (LH side).
Terminals Of ECU:
Pinouts:
4. CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR (RH SIDE)
a. Disconnect the R16 connector.
b. Check the voltage and continuity of each terminal of the wire harness side connector.
HINT: If the value is not as specified, there may be a malfunction in the wire harness side.
Pinouts:
c. Connect the R16 connector, and check the voltage between each terminal of the connector.
HINT: If the value is not as specified, replace the power window regulator switch assembly rear (RH side).
Terminals Of ECU:
5. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (BODY ECU) (REAR SIDE)
a. Disconnect the 2B, 2E, 2F and 2G driver side J/B connectors.
Pinouts:
b. Check the voltage and continuity of each terminal of the wire harness side connector.
HINT: If the value is not as specified, there may be a malfunction in the wire harness side.
Terminals Of ECU:
Pinouts:
6. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (BODY ECU) (LEFT SIDE)
a. Disconnect the B4 driver side J/B (body ECU) connector.
b. Check the continuity of each terminal of the wire harness side connector.
HINT: If the value is not as specified, there may be a malfunction in the wire harness side.
Pinouts:
c. Connect the B4 driver side J/B (body ECU) connector, and check the voltage between each terminal of the connector.
HINT: If the value is not as specified, replace the driver side J/B.