Rear Seat (Wagon)
REMOVALHINT: A bolt without a torque specification is shown in the standard bolt chart.
1. REMOVE SEAT CUSHION ASSEMBLY
Pull up the front portion of the seat cushion assembly, then remove it.
NOTE: Hold up the clip base to prevent the cushion frame from being distorted.
2. REMOVE SIDE SEAT BACK ASSEMBLY
a. Remove the bolt and floor anchor.
Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)
b. Using a screwdriver, remove the rear seat shoulder belt hole cover.
HINT: Tape the screwdriver tip before use.
c. Employ the same manner described above to the other sides.
d. Remove the bolt and side seat back assembly as shown in the illustration.
Torque: 18 N.m (184 kgf.cm, 13 ft.lbf)
3. REMOVE REAR SEAT FLOOR BOARD NO. 4
4. REMOVE DECK FLOOR BOX FRONT
5. REMOVE DECK BOARD NO. 2
6. REMOVE REAR FLOOR BOARD NO. 2
7. REMOVE REAR FLOOR BOARD NO. 3
8. REMOVE TONNEAU COVER ASSEMBLY
9. REMOVE REAR FLOOR FINISH PLATE
10. REMOVE DECK TRIM SIDE PANEL ASSEMBLY
11. REMOVE SEAT BACK ASSEMBLY
Remove the 7 bolts and seat back assembly.
Torque: 21 N.m (214 kgf.cm, 15 ft.lbf)
INSTALLATION
The installation procedures are the removal procedures in reverse order.