Tail Lamp: Service and Repair

Headlight And Taillight System Part 1:

Headlight And Taillight System Part 2:

Headlight And Taillight System Part 1:

Headlight And Taillight System - Sedan Part 2:

Headlight And Taillight System - Wagon Part 3:

REMOVAL

1. REMOVE HEADLIGHT

HINT: Follow the same procedure for RH as for LH.

a. Remove a part of LH front fender liner.
b. Remove a part of front bumper cover.




c. Remove the bolt, 2 nuts and 2 clips.




d. Lift up the front bumper and pull the headlight assembly towards the front of the vehicle, and disconnect the engagement of the headlight assembly.
e. Install LH headlight assembly.
f. Install a part of front bumper cover.
g. Install a part of front fender liner.
h. Inspect and adjust optical axis of headlight.

2. Sedan:
REMOVE REAR COMBINATION LIGHT

HINT:
- Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.
- Follow the same procedure for RH as for LH.




a. Remove luggage compartment trim cover No.2.
b. Remove luggage compartment trim cover.
c. Remove a part of LH luggage compartment trim side cover.




d. Remove the 2 rear light covers and 2 bolts.
e. Pull the pin toward the rear of the vehicle, and disconnect the engagement of 2 pins.
f. From the inside of the luggage room, separate the connector and disconnect the LH rear combination light assembly.




3. Wagon:
REMOVE REAR COMBINATION BULB

HINT:
- Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.
- Follow the same procedure for RH as for LH.

a. Remove floor board and deck side board LH.
b. Remove back door scuff plate.
c. Remove a part of deck side trim board LH.
d. Disconnect the bulb sockets and 3 nuts.




e. Remove the combination light assembly.




4. Sedan:
REMOVE REAR COMBINATION BULB

HINT:
- Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.
- Follow the same procedure for RH as for LH.

a. Remove a part of LH combination light assembly.

HINT: Remove the light unit from only the outside of the vehicle.

b. Remove the bulb sockets and remove the bulbs.




5. Wagon:
REMOVE REAR COMBINATION BULB

HINT:
- Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.
- Follow the same procedure for RH as for LH.

a. Remove a service hole cover.
b. Remove the bulb sockets and remove the bulbs.




6. Sedan:
REMOVE REAR LAMP ASSEMBLY

HINT:
- Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.
- Follow the same procedure for RH as for LH.

a. Remove a part of luggage compartment door trim.
b. Remove the nut.
c. Compress the claw to disconnect the engagement as shown in the illustration.
d. Separate the connector and remove the rear light assembly.




7. Wagon:
REMOVE REAR LAMP ASSEMBLY

HINT:
- Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.
- Follow the same procedure for RH as for LH.

a. Remove the back door trim service hole cover.
b. Compress the claw to disconnect the engagement as shown in the illustration.
c. Separate the connector and remove the rear light assembly.




8. Sedan:
REMOVE REAR LAMP BULB

HINT: Installation is in the reverse order of removal. Only it there is a specified procedure for installation it is shown.

a. Remove a part of luggage compartment door trim.
b. Remove the bulb socket and bulb.




9. Wagon:
REMOVE REAR LAMP BULB

HINT: Installation is in the reverse order of removal. Only if there is a specified procedure for installation it is shown.

a. Remove the back door trim service hole cover.
b. Remove the bulb socket and bulb.