Disassembly and Assembly

DISASSEMBLY
REMOVE SPEED SENSOR
a. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
SST 09520-00031 (09520-00040, 09521-00020)





b. Mount the axle hub assembly in a soft jaw vise.

NOTICE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.

c. Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the speed sensor.
SST 09520-00031 (09520-00040, 09521-00020), 09950-00020

NOTICE:
^ Do not allow any foreign matter sticking to the sensor rotor.
^ Pull out the speed sensor straightly not to damage the sensor rotor.
^ If damage has occurred to the sensor rotor, replace the axle hub assembly.
^ Do not scratch the contacting surface of the axle hub and speed sensor.

REASSEMBLY
INSTALL NEW SPEED SENSOR
a. Clean the contacting surface of the axle hub and a new speed sensor.

NOTICE: Do not allow any foreign matter sticking to the sensor rotor.

b. Place the speed sensor on the axle hub so that the connector is set at the bottom under the on-vehicle condition.





c. Using SST and a press, install a new speed sensor to the axle hub.
SST 09214-76011

NOTICE:
^ Do not tap the speed sensor with a hammer directly.
^ Check that there should be no foreign matter on the speed sensor detection portion.
^ Press in the speed sensor straightly and slowly.