Rear Seat
Rear Seat:
REAR SEAT
OVERHAUL
HINT: Installation is in the reverse order of the removal. But, the installation indicated only when it has a point.
1. REMOVE REAR SEAT CUSHION ASSEMBLY
a. Pull up the front portion of the seat cushion assembly, then remove it.
A: 100 mm (3.94 in.) or less
NOTE: In the case, hold the base of the clip up to prevent the cushion frame from being distorted.
2. REMOVE REAR SEAT HEADREST PLATE COVER
a. Using a screwdriver, remove the 2 rear seat headrest plate covers.
HINT: Tape the screwdriver tip before use.
b. Employ the same manner described above to the other side.
3. REMOVE WIND DEFLECTOR BOARD ASSEMBLY
a. Remove the 4 bolts and the wind deflector board assembly.
4. REMOVE REAR SEAT HEADREST PLATE
a. Using a screwdriver, remove the 2 rear seat headrest plates.
HINT: Tape the screwdriver tip before use.
b. Employ the same manner described above to the other side.
5. REMOVE REAR SEAT HEADREST ASSEMBLY
a. Remove the 4 nuts and the 2 rear seat headrest assemblies.
b. Employ the same manner described above to the other side.
6. REMOVE REAR SEAT BACK ASSEMBLY
a. Remove the 2 nuts, 2 bolts and the rear seat back assembly.
7. REMOVE BENCH TYPE REAR SEAT CUSHION COVER
a. Remove the hog rings and rear seat cushion cover.
8. REMOVE BENCH TYPE REAR SEAT BACK COVER
a. Remove the hog rings and rear seat back cover.
9. INSTALL BENCH TYPE REAR SEAT BACK COVER
a. Install the rear seat back cover to the rear seat back pad with new hog rings.
HINT:
- Do not damage the seat back cover nor make it dirty.
- When installing the hog rings, take care to prevent wrinkles as much as possible.
10. INSTALL BENCH TYPE REAR SEAT CUSHION COVER
a. Install the rear seat cushion cover to the rear seat cushion pad with new hog rings.
HINT:
- Do not damage the seat cushion cover nor make it dirty.
- When installing the hog rings, take care to prevent wrinkles as much as possible.
11. INSTALL REAR SEAT BACK ASSEMBLY
a. Install the rear seat back assembly with the 2 nuts and 2 bolts.
Torque: 18 N.m (184 kgf cm, 13 ft.lbf)
12. INSTALL REAR SEAT HEADREST ASSEMBLY
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
13. INSTALL WIND DEFLECTOR BOARD ASSEMBLY
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)