Actuator Check

LIST OF OPERATION METHODS




By operating each of the A/C control switches as shown the diagram, it is possible to enter the diagnosis check mode.



ACTUATOR CHECK




a. After entering the DTC check mode (Sensor Check Mode) press the R/F switch.
b. Since each damper, motor and relay automatically operates at 1 sec. intervals from step 1 in the temperature display, check the temperature and air flow visually and by hand.




If slower display is desired, press the UPDr switch and change it to step operation. Each time the UPDr switch is pressed, the display changes by 1 step.

HINT:
- Code are displayed in ascending order.
- To cancel the check mode, press the OFF switch.