Spiral Cable Sub Assembly
REPLACEMENT1. PRECAUTION
2. SEPARATE BATTERY NEGATIVE TERMINAL
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING WHEEL COVER LOWER NO.2
5. REMOVE SWITCH & VOLUME CASE
6. REMOVE STEERING PAD SWITCH MODULATOR
7. REMOVE HORN BUTTON ASSY
8. REMOVE STEERING WHEEL ASSY
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05020)
9. REMOVE STEERING COLUMN COVER LWR
a. Remove the 3 screws and column lower cover.
10. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY
11. REMOVE SPIRAL CABLE SUB-ASSY
a. Slide the column upper cover.
b. Disconnect the 2 connectors.
c. Release the 3 claws and remove the spiral cable sub-assy.
12. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
a. Check that the front wheels are facing straight ahead.
13. INSTALL SPIRAL CABLE SUB-ASSY
a. Set the turn signal switch in neutral position.
NOTE: Make sure of the neutral position since the pin of the turn signal switch may be snapped.
b. Engage the 3 claws and install the spiral cable sub-assy.
NOTE: When replacing the spiral cable sub-assy with new one, remove the lock pin before installing the handle.
c. Connect the airbag connector and connector.
14. INSTALL STEERING COLUMN COVER LWR
a. Install the steering column lower cover with the 3 screws.
15. INSPECT SPIRAL CABLE SUB-ASSY
a. If the following condition is identified, replace the spiral cable sub-assy with new one.
Condition: Scratches or cracks on the connector Cracks, dents or chipping of the spiral cable sub-assy
16. CENTER SPIRAL CABLE
a. Check that the ignition switch is OFF.
b. Check that the battery negative terminal is disconnected.
NOTE: Do not start the operation for 90 seconds after removing the terminal.
c. Turn the cable counterclockwise by hand until it becomes harder to turn.
HINT: The cable will rotate about 2.5 turns to either left or right of the center.
d. Then rotate the cable clockwise about 2.5 turns to align the marks.
17. INSTALL STEERING WHEEL ASSY
Torque: 35 N.m (360 kgf.cm, 26 ft.lbf)
18. INSPECT STEERING WHEEL CENTER POINT
19. INSTALL HORN BUTTON ASSY
Torque: 8.8 N.m (90 kgf.cm, 78 in.lbf)
20. INSPECT HORN BUTTON ASSY
21. INSPECT SRS WARNING LIGHT