Without Scan Tool

DTC CLEARANCE (Not using diagnosis check wire)

a. When the ignition switch is turned off, the diagnostic trouble code is cleared.

HINT: DTC might not be cleared by turning the ignition switch OFF. In this case, proceed to the next step.

DTC CLEARANCE (Using diagnosis check wire)

a. Using SST; connect the terminal Tc and CG of the DLC3.
b. Turn the ignition switch to ON and wait for approx. 6 seconds.
c. The SRS warning light comes on 2 to 4 sec. later. Within 1 to 5 sec. after that, ground terminal Tc of the DLC3.
d. The SRS warning light goes off 2 to 4 sec. after grounding terminal Tc. Within 1 to 5 sec. after that, release ground from terminal Tc again.
e. The SRS warning light comes on again 2 to 4 sec. later. Within 1 to 5 sec. after that, ground terminal Tc of the DLC3 again.




f. The SRS warning light goes off 2 to 4 Sec. later. Within 1 Sec. after that, normal code is output indicating that DTC deletion is completed.
If DTCs are to cleared, repeat the above procedure until the codes are cleared.