Canada - Entertainment - Audio Door
BulletinTSB2074R
Issue Date
March 01, 2005
Title
AUDIO DOOR REPLACEMENT
Component
BODY COMPONENT
Models
'02 - '05 SC 430
INTRODUCTION:
The audio system door can be replaced separately without having to replace the complete lower sub-assembly. The following repair procedure has been developed.
APPLICABLE VEHICLES:
- 2002 - 2005 model year SC430 vehicles.
PARTS INFORMATION:
COMPONENTS:
WARRANTY INFORMATION:
REPAIR PROCEDURES:
NOTE:
Refer to the procedure for removing the radio receiver assembly from the instrument cluster finish panel sub-assembly LWR CTR found in ETAS, applicable model year SC 430 Repair Manual: Audio & Visual System: Radio Receiver Assy: Replacement (SC 430).
1. Replace Instrument Cluster Finish Panel LWR CTR.
A. Remove the 2 clips shown in the illustration.
B. Remove the 3 screws from the backside of the instrument cluster finish panel CTR LWR and then remove the instrument cluster finish panel CTR LWR.
NOTE:
Be careful not to damage the 3 positioning ribs in area A.
C. Install a new instrument cluster finish panel CTR LWR onto the original instrument cluster finish panel sub-assembly LWR CTR.
D. Tighten the 3 screws.
Torque: 0.69 to 0.71 N-m (6.83 to 7.24 kgf-cm, 0.49 to 0.52 ft-lbf)
E. Fully close the audio system finish panel by sliding the motor.
NOTE:
Do not close the audio system finish panel door by holding and sliding the door.
F. Install the 2 new clips from inward to outward in the areas B.
2. Reinstall and Inspect.
A. After assembling the instrument cluster finish panel sub-assembly LWR CTR, visually check the appearance to make sure that the instrument cluster finish panel CTR LWR is centered.
B. Check that audio system finish panel operates properly.
NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.