Suspension Control ( Automatic - Electronic Level )

DIAGNOSTIC TROUBLE CODE CHART

C1715/15 - C1779/79:

HINT:
- Connect the LED (10 - 20 mA) and resistor (500 Ohms to 1 kOhm) in series between terminals TEM and CG of the DLC3.
- Using SST 09843-18040, connect terminals Tc and CG of the DLC3.
- If any abnormality is not found when the parts are inspected, inspect the absorber control ECU.
- If a malfunction code is displayed during the DTC check, check the circuit listed for that code. For details of each code, refer to the respective "DTC No." in the DTC chart.

HINT: DTCs C1715/15, C1716/16, C1717/17, C1776/76 and C1779/79 can be detected only in the input signal inspecting mode.

DTC of the input signal check

C1782/82 - C1797/97:

If a malfunction code is displayed during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to the respective "DTC No." in the DTC chart.