CAN Communication System
TERMINALS OF ECU1. DLC3
Terminals Of ECU:
a. Check DLC3.
1. Turn the ignition switch off.
Pinouts:
2. Measure the resistance according to the value(s) in the table.
2. SKID CONTROL ECU
Terminals Of ECU:
a. Check skid control ECU.
1. Turn the ignition switch off.
2. Disconnect the connector (S1) from the skid control ECU.
Pinouts:
3. Measure the resistance according to the value(s) in the table.
Terminals Of ECU:
b. Check the skid control ECU harness side connector (S1).
1. Turn the ignition switch off.
2. Disconnect the connector (S1) from the skid control ECU
Pinouts:
3. Measure the resistance according to the value(s) in the table.
3. STEERING SENSOR
Terminals Of ECU:
a. Check the harness side connector (S9) of the steering sensor.
1. Turn the ignition switch off.
2. Disconnect the connector (S9) from the steering sensor.
Pinouts:
3. Measure the resistance according to the value(s) in the table.
4. YAW RATE SENSOR
Terminals Of ECU:
a. Check the yaw rate sensor harness side connector (Y1).
1. Turn the ignition switch off.
2. Disconnect the connector (Y1) from the yaw rate sensor.
Pinouts:
3. Measure the resistance according to the value(s) in the table.