Without Scan Tool
DTC CLEARClear the DTCs
1. When the ignition switch is turned off, the DTCs are cleared.
HINT: Depending on the DTC, the code may not be cleared by turning off the ignition switch. In this case, proceed to the next procedure.
2. Using SST, connect the TC and CG of the DLC3, and then turn the ignition switch to the ON position.
SST 09843-18040
3. Disconnect the TC of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds.
4. Within 2 to 4 seconds after the SRS warning light comes on, connect the TC and CG of the DLC3.
5. The SRS warning light should go off within 2 to 4 seconds after connecting the TC and CG of the DLC3. Then, disconnect the TC terminal within 2 to 4 seconds after the SRS warning light goes off.
6. The SRS warning light comes on again within 2 to 4 seconds after disconnecting the TC terminal. Then, reconnect terminals TC and CG within 2 to 4 seconds after the SRS warning light comes on, and connect the TC and CG of the DLC3.
7. Check if the SRS warning light goes off within 2 to 4 seconds after connecting the TC and CG of the DLC3, and the normal system code is output within 1 second after the SRS warning light goes off.
If DTCs are not cleared, repeat the procedure until the codes are cleared.