Component Tests and General Diagnostics
FUEL LID OPENER SYSTEMINSPECTION
1. INSPECT FUEL LID OPENER SWITCH CONTINUITY
a. Check that continuity exists between terminals with the switch ON (Lever pulled).
b. Check that no continuity exists between terminals with the switch OFF (Lever free).
If continuity is not as specified, replace the switch assembly.
2. INSPECT FUEL LID OPENER SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the circuits connected to other parts.
3. INSPECT FUEL LID OPENER SOLENOID OPERATION
a. Connect the positive (+) lead from the battery to terminal 2 and negative (-) lead to terminal 3.
b. Check that the solenoid operates in the fuel lid opening. If operation is not as specified, replace the solenoid.
4. INSPECT FUEL LID OPENER MOTOR CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the circuits connected to other parts.