Component Tests and General Diagnostics

INSPECTION







1. INSPECT TURN SIGNAL SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







2. Connector disconnected:
INSPECT TURN SIGNAL SWITCH CIRCUIT
Disconnect the connector from the combination switch and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the wire harness.







3. Connector connected:
INSPECT TURN SIGNAL SWITCH CIRCUIT
Connect the wire harness side connector to the combination switch and inspect the connector form the back side, as shown.
If circuit is not as specified, inspect the circuits connected to other parts.