Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor:

REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE OIL DIPSTICK AND GUIDE FOR ENGINE
3. REMOVE OIL DIPSTICK AND GUIDE FOR A/T
4. REMOVE AIR INTAKE CHAMBER
5. REMOVE VACUUM CONTROL VALVE SET AND NO.2 VACUUM PIPE
6. REMOVE NO.3 TIMING BELT COVER
7. DISCONNECT HOSES AND ENGINE WIRE
a. Disconnect the air assist hose from the intake manifold.
b. Disconnect the water bypass hose (from the water outlet) from the throttle body.
c. Disconnect the 2 ground terminals from the intake manifold.

HINT: At time of the installation, tighten so that each calking part should be inside.

d. Disconnect the throttle position sensor connector.
e. Disconnect the 6 injector connectors.
f. Disconnect the camshaft position sensor connector.
g. Disconnect the knock sensor 2 connector.
h. Disconnect the starter connector.
i. Disconnect the engine wire clamp from the clamp bracket on the intake manifold.
j. Remove the 3 nuts, and disconnect the engine wire protector from the intake manifold.

8. REMOVE FUEL PRESSURE PULSATION DAMPER
9. REMOVE PS PUMP REAR STAY

Torque: 39.2 Nm (400 kgf.cm, 29 ft.lbf)

10. REMOVE INTAKE MANIFOLD ASSEMBLY




11. REMOVE CAMSHAFT POSITION SENSOR
Remove the 2 bolts and sensor.

Torque: 9.0 Nm (90 kgf.cm, 80 in.lbf)

INSTALLATION
Installation is in the reverse order of removal.