Removal and Installation
Curtain Shield Airbag Assembly:
REMOVAL
NOTE:
- If the wiring connector of the SRS is disconnected and the ignition switch is at ON position, DTCs will be recorded.
- Never use any airbag parts removed from another vehicle. When replacing parts, replace them with new ones.
1. REMOVE ROOF HEADLINING
2. In case without removing inflater:
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
a. In the order shown in the illustration, remove the bolts and deployment section of the curtain shield airbag assembly.
b. Put the removed curtain shield airbag assembly into a clear plastic bag and put it on the instrument panel.
CAUTION: Never disassemble the curtain shield airbag assembly.
NOTE: The clear plastic bag is not reusable.
3. REMOVE INSTRUMENT PANEL.
4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
a. Disengage the clamp and remove the curtain shield air-bag assembly connector.
b. Disconnect the connector for curtain sealed airbag assembly.
c. Disengage the claw and disconnect the vehicle wire harness from the bracket of the curtain shield airbag assembly.
d. In the order shown in the illustration, remove the bolts and curtain shield airbag assembly.
e. Put the removed curtain shield airbag assembly into a clear plastic bag and keep it in a safe place.
CAUTION: Never disassemble the curtain shield airbag assembly.
NOTE: The protection bag is not reusable.
INSTALLATION
NOTE: Never use airbag parts removed from another vehicle. When replacing parts, replace them with new parts.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
a. In order shown in the illustration, install the curtain shield airbag assembly with the 6 bolts.
Torque: 9.8 N.m (100 kgf.cm, 86 in.lbf)
CAUTION: Pay attention not to twist the deployment section of the curtain shield airbag assembly.
NOTE:
- Make sure that the curtain shield airbag assembly is installed with the specified torque.
- If the curtain shield airbag assembly has been dropped, or any cracks, dents or other defects in the case or connector, replace the curtain shield airbag assembly with a new one.
- When installing the curtain shield airbag assembly, be careful to prevent it from being pinched between other parts.
b. Connect the connector of the curtain shield airbag assembly.
2. INSTALL INSTRUMENT PANEL
3. When inflator is installed:
INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
In order shown in the illustration, install the deployment section of the curtain shield airbag assembly with the 4 bolts.
Torque: 9.8 N.m (100 kgf.cm, 86 in.lbf)
CAUTION: Pay attention not to twist it.
NOTE:
- Make sure that the curtain shield airbag assembly is installed with the specified torque.
- When installing the curtain shield airbag assembly, be careful to prevent it from being pinched between other parts.
4. INSTALL ROOF HEADLINING