Rear Wiper and Washer (Wagon)

REMOVAL




1. REMOVE BACK DOOR TRIM BOARD UPPER
Using a screwdriver, remove the back door trim board upper.

HINT: Tape the screwdriver tip before use.




2. REMOVE BACK DOOR TRIM COVERS
a. Insert a screwdriver between the back door panel and back door trim cover to pry the cover.

HINT: Tape the screwdriver tip before use.

b. Employ the same manner described above to the other side.




3. REMOVE BACK DOOR TRIM BOARD
a. Remove the clip and back door handle.
b. Using a screwdriver, remove the back door trim board.

HINT: Tape the screwdriver tip before use.




4. REMOVE REAR WIPER ARM
a. Open the wiper arm cover.
b. Place matchmarks on the wiper arm and wiper motor.
c. Remove the nut and rear wiper arm.




5. REMOVE REAR WIPER MOTOR
a. Remove the nut and washer on the outer side of the back door panel.
b. Disconnect the connector.
c. Remove the 3 bolts and rear wiper motor.

INSTALLATION




1. INSTALL REAR WIPER MOTOR
a. Install the rear wiper motor with the 3 bolts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

b. Connect the connector.
c. Install the nut and washer on the outer side of the back door panel.

Torque: 12 N.m (122 kgf.cm, 9 ft.lbf)




2. INSTALL REAR WIPER ARM
a. Install the wiper arm and tighten the nut by hand. Operate the wiper once and turn the wiper switch OFF.
b. Align the matchmarks on the wiper arm and wiper motor.
c. Install the rear wiper arm with the nut.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

d. Install the wiper arm cover.




3. INSTALL BACK DOOR TRIM BOARD
a. Install the back door trim board to the back door panel.
b. Install the back door handle with the clip.




4. INSTALL BACK DOOR TRIM COVERS
Install the trim covers to the body.




5. INSTALL BACK DOOR TRIM BOARD UPPER
Install the back door trim board upper to the body.