Front
FRONT DISC THICKNESSa. Using a micrometer, measure the disc thickness.
Standard thickness: 30.0 mm (1.181 inch)
Minimum thickness: 28.0 mm (1.102 inch)
If the disc thickness is less than the minimum, replace the disc.
FRONT DISC RUNOUT
a. Tighten the disc with the 3 hub nuts.
HINT: Use SST 09330-00021 to hold the disc during measurement.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Using a dial indicator, measure the disc runout 10 mm inside (0.39 inch) the outer edge of the disc.
Maximum disc runout: 0.05 mm (0.0020 inch)
c. If the runout exceeds the maximum value, change the installation positions of the disc and axle so that the runout will become minimal. If the runout exceeds the maximum even when the installation positions are changed, check the bearing play in the axial direction and the axle hub runout. If the bearing play and the axle hub runout are normal and if the disc thickness is not within the specified range, shave the disc. If the disc thickness is less than the minimum, replace the disc.