Pinout Values and Diagnostic Parameters
TERMINALS OF ECUTerminals Of ECU / Pinouts - Engine Room No,2 Relay Block Part 1:
Terminals Of ECU / Pinouts - Engine Room No.2 Relay Block Part 2:
1. ENGINE ROOM NO.2 RELAY BLOCK
Terminals Of ECU / Pinouts - Driver Side Junction Block Part 1:
Terminals Of ECU / Pinouts - Driver Side Junction Block Part 2:
Terminals Of ECU / Pinouts - Driver Side Junction Block Part 3:
2. DRIVER SIDE JUNCTION BLOCK
Terminals Of ECU / Pinouts - Passenger Side Junction Block Part 1:
Terminals Of ECU / Pinouts - Passenger Side Junction Block Part 2:
3. PASSENGER SIDE JUNCTION BLOCK
Terminals Of ECU / Pinouts - Luggage Room Junction Block Part 1:
Terminals Of ECU / Pinouts - Luggage Room Junction Block Part 2:
4. LUGGAGE ROOM JUNCTION BLOCK
Terminals Of ECU / Pinouts - Combination Switch:
5. COMBINATION SWITCH
Terminals Of ECU / Pinouts - Driver Door ECU:
6. DRIVER DOOR ECU
Terminals Of ECU / Pinouts - Passenger Door ECU:
7. PASSENGER DOOR ECU
Terminals Of ECU / Pinouts - Rear Door LH ECU:
8. REAR DOOR LH ECU
Terminals Of ECU / Pinouts - Rear Door RH ECU:
9. REAR DOOR RH ECU
Terminals Of ECU / Pinouts - AFS ECU Part 1:
Terminals Of ECU / Pinouts - AFS ECU Part 2:
10. AFS ECU
Waveform 1
HINT:
- Terminal: SPDL - GND, SPDR - GND
- Gauge set: 5 V / DIV. 2 ms / DIV
- Condition: Vehicle is driving at approximately 30 km/h (19 mph)
Waveform 2
HINT:
- Terminal: LR1+. LR1-. LR2+. LH2- - GND
LL1+. LL1-. LL2+. LL2- - GND
- Gauge set: 5 V / DIV. 20 ms / DIV
- Condition: The DRL system is on with engine running or the light control switch is in the HEAD position when the vehicle standing still or bouncing.
If the value is not within the standard range, it is possible there is some defect on the vehicle side. Inspect the fuse, wire harness and connector.