Without Scan Tool

DTC CLEARANCE (Not using diagnosis check wire)

When the ignition switch is turned off, the diagnostic trouble code is cleared.

HINT: DTC might not be cleared by turning the ignition switch OFF. In this case, proceed to the next step.

DTC CLEARANCE (Using diagnosis check wire)

a. Using SST, connect the terminal Tc and CG of the DLC3.
b. Turn the ignition switch to ON and wait for approx. 6 seconds.
c. The SRS warning light comes on 2 to 4 sec. later. Within 1 to 5 sec. after that, ground terminal Tc of the DLC3.
d. The SRS warning light goes off 2 to 4 sec. after grounding terminal Tc. Within 1 to 5 sec. after that, release ground from terminal Tc again.
e. The SRS warning light comes on again 2 to 4 sec. later. Within 1 to 5 sec. after that, ground terminal Tc of the DLC3 again.




f. The SRS warning light goes off 2 to 4 sec. later. Within 1 sec. after that, normal code is output indicating that DTC deletion is completed.
If DTCs are to cleared, repeat the above procedure until the codes are cleared.