Memory Positioning Switch: Testing and Inspection

CHECK MEMORY AND REACTIVATION FUNCTION
a. Turn the ignition switch ON and move the shift lever into the P position.
b. Move the seat into the foremost position and uppermost position using each seat switch.
c. Check that the buzzer sounds for 0.5 seconds and the seat position is recorded when the SW1 switch is pressed while the SET switch is held down.
d. Move the seat out of the foremost position and uppermost position using each seat switch.
e. Check that the buzzer sounds for 0.5 seconds and the seat position is recorded when the SW2 switch is pressed while the SET switch is held down.
f. Check that the buzzer sounds for 0.1 seconds and the seat automatically moves into the foremost position and uppermost position (set positions) when the SW1 switch is pressed.
g. Check that the buzzer sounds for 0.1 seconds and the seat automatically moves out of the foremost position and uppermost position (set positions) when the SW2 switch is pressed.
h. Check that the seat automatically moves into the set position when the SW1 or SW2 switch is pressed within 30 seconds after the ignition switch is turned OFF, the key is pulled out from the key cylinder and the driver side door is opened.
i. Move the seat into the maximum positions of the slide movement, and disconnect the negative terminal of the battery while the memory switch is pressed. Then leave the seat in that position for 3 minutes. The seat position memory will be erased.
j. Move the seat into all the maximum positions (front/rear and up/down) using each seat switch.
k. Check that the seat does not move (the seat position is not recorded) when the SW1 switch or the SW2 switch is pressed after the SW1 switch and SW2 switch are pressed together while the SET switch is held down.







INSPECT SEAT MEMORY SWITCH
a. Measure the resistance between the terminals when each switch is operated.
If the result is not as specified, replace the switch.