Power Seat Motor: Testing and Inspection

CHECK POWER SEAT MOTOR ASSEMBLY
(SLIDING, FRONT VERTICAL, REAR VERTICAL AND RECLINING FUNCTIONS)
a. Check PTC operation inside the power seat motor.

HINT: The PTC thermistor's resistance increases when the power seat switch is held down even after the power seat has been moved to the maximum in one direction. After the resistance increases, current is shut off to prevent a short circuit.

NOTE: Perform steps (1) to (4) for the full range of motion for each power seat function.

1. Choose a power seat function. Operate the power seat switch and move the seat to the maximum in one direction. Keep the seat in that position for approximately 60 seconds.
2. Operate the power seat switch again and continue to try to move the seat in the same direction as in step (1). Measure the amount of time elapsed before the electrical current is automatically cut. Check if the electrical current has shut off by making sure the sound of the motor has stopped.

Standard: 4 to 90 seconds

3. After the current has stopped, release the power seat switch and wait for approximately 60 seconds.
4. Operate the same power seat switch and move the seat to the opposite extreme of the direction in step (1). Check that the motor operates.
5. Repeat steps (1) to (4) for the remaining power seat functions.







INSPECT FRONT LH SEAT ASSEMBLY
a. Check slide motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the slide motor connector terminals.
OK:
If the result is not as specified, replace the front LH seat assembly.







b. Check front vertical motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the vertical motor connector terminals.
OK:
If the result is not as specified, replace the front LH seat assembly.







c. Check lifter motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the rear vertical motor connector terminals.
OK:
If the result is not as specified, replace the front LH seat assembly.







d. Check reclining motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the reclining motor connector terminals.
OK:
If the result is not as specified, replace the front LH seat assembly.

INSPECT FRONT RH SEAT ASSEMBLY







a. Check slide motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the slide motor connector terminals.
OK:
If the result is not as specified, replace the front RH seat assembly.







b. Check front vertical motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the vertical motor connector terminals.
OK:
If the result is not as specified, replace the front RH seat assembly.







c. Check lifter motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the rear vertical motor connector terminals.
OK:
If the result is not as specified, replace the front RH seat assembly.







d. Check reclining motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the reclining motor connector terminals.
OK:
If the result is not as specified, replace the front RH seat assembly.







INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (DRIVER SEAT POSITION)
a. Check lumbar support motor operation.
1. Check if the motor rotates smoothly when the battery is connected to the lumbar support motor connector terminals.
OK:
If the result is not as specified, replace the lumber support adjuster assembly LH.