Fog/Driving Lamp: Service and Repair
FRONT FOG LAMP ASSEMBLY LHOVERHAUL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Installation is in the reverse order of removal.
1. REMOVE FRONT BUMPER ASSEMBLY
2. REMOVE FOG LAMP SET LH
a. Remove the bolt and screw.
b. Move the fog lamp set LH in the direction indicated by the arrow, disengage the pin, and remove the fog lamp set LH.
3. REMOVE FRONT BUMPER EXTENSION MOULDING LH
a. Disengage the 3 claws and remove the front bumper extension moulding LH.
4. REMOVE FOG LAMP BRACKET LH
a. Disengage the 2 claws and the 2 pins and remove the fog lamp bracket LH.
b. Disengage the 2 claws and the pin and remove the fog lamp bearing LH.
5. REMOVE FOG LAMP BULB
a. Turn the fog lamp bulb in the direction as shown in the illustration and remove the fog lamp bulb.
6. VEHICLE PREPARATION FOR FOG LAMP AIM ADJUSTMENT
7. PREPARATION FOR FOG LAMP AIMING
8. FOG LAMP AIMING INSPECTION
9. FOG LAMP AIMING ADJUSTMENT