Procedures

Headlamp Assy LH Part 1:

Headlamp Assy LH Part 2:

REPAIR

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- If the area where the headlamp unit LH is installed is broken, the repairs listed below can be performed inexpensively through the use of a repair use bracket. This may only be done if the headlamp assembly LH itself is not damaged.

1. REMOVE RADIATOR LOWER AIR DEFLECTOR
2. REMOVE FRONT BUMPER ASSEMBLY
3. REMOVE HEADLAMP ASSEMBLY LH
4. INSTALL HEADLAMP PROTECTOR RETAINER UPPER LH

HINT:
- If the installation area of the headlamp assembly LH is damaged, use the supply bracket for low-cost repair.
- Ensure that the headlamp assembly LH is not damaged.




a. Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTE: After cutting off the part, place the headlamp protector retainer UPPER LH against the bosses and gradually file away until installation is possible.




b. Install the headlamp protector retainer UPPER LH with the 2 screws.

5. INSTALL HEADLAMP PROTECTOR RETAINER LWR LH

HINT:
- If the installation area of the headlamp assembly LH is damaged,use the supply bracket for low-cost repair.
- Ensure that the headlamp assembly LH is not damaged.




a. Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTE: After cutting off the part, place the headlamp protector retainer LWR LH against the bosses and gradually file away until installation is possible.




b. Install the headlamp protector retainer LWR LH with the 2 screws.

6. VEHICLE PREPARATION FOR HEADLAMP AIM ADJUSTMENT
7. PREPARATION FOR HEADLAMP AIMING (Using a tester)
8. PREPARATION FOR HEADLAMP AIMING (Using a screen)
9. HEADLAMP AIMING INSPECTION
10. HEADLAMP AIMING ADJUSTMENT
11. VEHICLE PREPARATION FOR FOG LAMP AIM ADJUSTMENT
12. PREPARATION FOR FOG LAMP AIMING
13. FOG LAMP AIMING INSPECTION
14. FOG LAMP AIMING ADJUSTMENT