Inspection

INSPECTION







1. HEADLAMP DIMMER SWITCH ASSEMBLY
a. Inspect light control switch continuity.
1. Check that there is continuity between terminals at each switch position as shown in the chart.




b. Inspect headlight dimmer switch continuity.
1. Check that there is continuity between terminals at each switch position as shown in the chart.




c. Inspect turn signal switch continuity.
1. Check that there is continuity between terminals at each switch position as shown in the chart.




d. Inspect front fog light switch continuity.
1. Check that there is continuity between terminals at each switch position as shown in the chart.




2. HAZARD WARNING SIGNAL SWITCH ASSEMBLY
a. Check that there is continuity between terminals at each switch position as shown in the chart.
b. Inspect illumination operation.
1. Connect the positive (+) lead from the battery to terminal 8 and negative (-) lead to terminal 9, then check that the illumination lights up.




3. LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
a. Inspect luggage compartment door courtesy lamp switch continuity.
1. Check that there is continuity between terminal 2 and body ground when switch is operated.

Standard:
ON (When shaft is pressed): No continuity
OFF (When shaft is not pressed): Continuity







4. FOG LAMP RELAY
a. Inspect relay continuity.




5. ROOF CONSOLE BOX ASSEMBLY
a. Inspect map lamp continuity.
1. Check that there is continuity between terminal 6 and 7 when switch is operated.

Standard:
ON: Continuity
OFF: No continuity







6. ROOM LAMP ASSEMBLY NO.1
a. Inspect room lamp assembly No. 1 continuity.
1. Check that there is continuity between terminals at each switch position as shown in the chart.

7. COURTESY LAMP ASSEMBLY
a. Inspect courtesy lamp assembly continuity.
1. Check that there is continuity between terminals when switch is operated.

Standard:
ON (When shaft is pressed): No continuity
OFF (When shaft is not pressed): Continuity

8. GLOVE BOX LAMP ASSEMBLY
a. Inspect glove box lamp assembly continuity.
1. Check that there is continuity between terminals when switch is operated.

Standard:
ON (When shaft is pressed): No continuity
OFF (When shaft is not pressed): Continuity

9. LUGGAGE COMPARTMENT LAMP ASSEMBLY NO.1
a. Inspect luggage compartment lamp assembly No. 1.
b. Check that there is continuity between terminals when switch is operated.

Standard:
ON: Continuity
OFF: No continuity







10. TAIL LAMP RELAY
a. Inspect relay continuity.







11. DAYTIME RUNNING LIGHT RELAY NO.1
a. Inspect relay continuity.







12. DAYTIME RUNNING LIGHT RELAY NO.2
a. Inspect relay continuity.