Pinout Values and Diagnostic Parameters
TERMINALS OF ECUTerminals Of Control Module/Pinouts Part 1:
Terminals Of Control Module/Pinouts Part 2:
1. Multiplex Network Body Computer
Terminals Of Control Module/Pinouts:
2. Headlight Beam Level Control ECU:
a. Signal waveform 1
HINT:
- Terminal: SPDR - GND
- Gauge set: 5 V / DIV. 2 ms / DIV
- Condition: Drive at about 30 km/h (19 mile/h)
b. Signal waveform 2
HINT:
- Terminal: RH+. RHT. RH-. RHE - RHG
LH+. LHT. LH-. LHE - LHG
- Gauge set: 5 V / DIV. 10 ms / DIV
- Condition: Light control switch HEAD or DRL system is ON and engine running, when keeping and bouncing the vehicle
If the value is not within the standard range, some defects on the vehicle side are suspect. Inspect the fuse, wire harness and connector.
Terminals Of Control Module/Pinouts:
3. Power Window Regulator Master Switch Assy
Terminals Of Control Module/Pinouts:
4. Power Window Regulator Switch Assy