Rear Wheel Alignment

ADJUSTMENT
1. INSPECT TIRE
2. MEASURE VEHICLE HEIGHT

NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.





3. INSPECT TOE-IN





Toe-in

If the toe-in is not within the specified value, inspect and replace the suspension parts if necessary.
4. ADJUST TOE-IN





a. Measure the lengths of the right and left No. 2 lower suspension arms.
No. 2 lower suspension arm length difference: 1.0 mm (0.039 inch) or less
If the left-right difference is larger than 1.0 mm (0.039 inch), adjust it by following the procedures.
b. Loosen the lock nuts.





c. Turn the right and left adjusting tube by an equal amount to adjust toe-in.

HINT:
^ Try to adjust the toe-in to the center value.
^ One turn of the each adjusting tube will adjust the toe-in by approximately 67' (1°12', 10.8 mm, 0.425 inch).

d. Torque the lock nut.
Torque: 56 Nm (570 kgf-cm, 41 ft. lbs.)





5. INSPECT CAMBER

HINT: Camber is not adjustable. If the measurement is not within the specification, inspect the suspension parts for damaged and/or worn-out parts and replace them if necessary.