Initialization

INITIALIZATION

RESET MEMORY

CAUTION: Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

NOTE: Hand-held tester only

HINT: The ECM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.

Reset procedure is as follows.




a. Turn the ignition switch off:
b. Connect the hand-held tester to the DLC3.
c. Turn the ignition switch to the ON position and turn the hand-held tester main switch on.
d. Select the item "DIAGNOSIS/ENHANCED OBD II".
e. Perform the reset memory procedure from the ENGINE menu.

CAUTION: After performing the RESET MEMORY, be sure to perform the ROAD TEST described.

HINT: The ECM learns through use of the ROAD TEST.