Front Right Sensor

Air Bag Front RH Sensor:

AIRBAG FRONT RH SENSOR

REPLACEMENT

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE ENGINE UNDER COVER NO.1




4. REMOVE AIR BAG FRONT RH SENSOR
a. Remove the bolt and airbag front RH sensor.




b. Disconnect the connector from the airbag front RH sensor.

HINT: Insert a screw driver in any of the three opening sections of the sensor and slide the sensor to disconnect it from the connector.

5. INSPECT AIR BAG FRONT RH SENSOR
6. INSTALL AIR BAG FRONT RH SENSOR
a. Check that the ignition switch turn OFF.
b. Check that the battery negative terminal is disconnected.

NOTE: Do not start the operation for 90 seconds after removing the terminal.

c. Install the airbag front RH sensor with the bolt.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

d. Connect the connector to the airbag front RH sensor.
e. Check that no play is identified.

7. INSPECT SRS WARNING LIGHT