Disassembly and Assembly

DISASSEMBLY
1. REMOVE FRONT HUB GREASE CAP
Using a screwdriver, remove the grease cap from the steering knuckle.





2. REMOVE FRONT AXLE HUB LOCK NUT AND ABS SPEED SENSOR ROTOR
a. Clamp the axle hub in a soft jaw vise.

HINT: Close vise until it holds hub bolt. Do not tighten further.

b. Using a chisel and hammer, loosen the staked part of the lock nut.
c. Using a 36 mm socket wrench, remove the lock nut.
d. Remove the ABS speed sensor rotor.

NOTICE: Take care not to scratch the serrations of the sensor rotor.

3. REMOVE AXLE HUB FROM STEERING KNUCKLE
a. Remove the 4 bolts and shift the brake dust cover toward the outside.





b. Using SST, remove the axle hub from the steering knuckle.
SST 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04051, 09957-04010, 09958-04011)





4. REMOVE INNER RACE (OUTSIDE) FROM AXLE HUB
Using SST, remove the inner race from the axle hub.
SST 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)





5. REMOVE OIL SEAL
Using SST, remove the oil seal from the steering knuckle.
SST 09308-00010
6. REMOVE BEARING FROM STEERING KNUCKLE
a. Using snap ring pliers, remove the snap ring.





b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09950-60010 (09951-00560)

REASSEMBLY
1. INSTALL BEARING





a. Using SST and a press, install a new bearing to steering knuckle.
SST 09309-36010, 09950-60020 (09951-00720), 09950-70010 (09951-07150)

NOTICE: If the inner race and balls come loose from the bearing outer race, make sure to install them on the same side as before.

b. Using snap ring pliers, install a new snap ring.
2. INSTALL OIL SEAL
a. Install the inner race (outside).





b. Using SST and a hammer, install a new oil seal until it is flush with the end surface of the steering knuckle.
SST 09608-32010
c. Coat MP grease to the oil seal lip.
3. INSTALL AXLE HUB TO STEERING KNUCKLE
a. Install the brake dust cover to the steering knuckle with the 4 bolts.
Torque: 8.3 Nm (85 kgf-cm, 74 inch lbs.)





b. Using SST and a press, install the axle hub to the steering knuckle.
SST 09316-60011 (09316-00011, 09316-00071), 09608-32010
4. INSTALL ABS SPEED SENSOR ROTOR

NOTICE: Do not scratch the serrations of the sensor rotor.

5. INSTALL AXLE HUB LOCK NUT
a. Install a new axle hub lock nut.
Torque: 199 Nm (2,030 kgf-cm, 147 ft. lbs.)
b. Using a chisel and hammer, stake the lock nut.
6. INSTALL FRONT HUB GREASE CAP
Using a screwdriver and hammer, install the grease cap to the steering knuckle.