Operation CHARM: Car repair manuals for everyone.

Component Tests and General Diagnostics

STOP LIGHT SYSTEM

INSPECTION







1. INSPECT STOP LIGHT SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







2. INSPECT STOP LIGHT SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the power source or wire harness.




3. INSPECT HI-MOUNTED STOP LIGHT CONTINUITY
Using an ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.







4. INSPECT HI-MOUNTED STOP LIGHT CIRCUIT
Disconnect the connector from the light and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the power source or wire harness.

5. INSPECT LIGHT FAILURE SENSOR