Cruise Control Switch: Service and Repair

Cruise Control Main Switch Assy:

CRUISE CONTROL MAIN SWITCH ASSEMBLY

REPLACEMENT

HINT: The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat pretensioner activation.

2. REMOVE STEERING WHEEL COVER LOWER NO.2




3. REMOVE SWITCH & VOLUME CASE
a. Apply protective tape to the steering wheel boss cover lower as shown in the illustration.
b. Using a screwdriver, detach the 3 claws and remove the case.

HINT: Tape the screwdriver tip before use.




4. REMOVE STEERING PAD SWITCH MODULATOR
a. Remove the 2 screws.
b. Remove the modulator and then disconnect the connector.

5. REMOVE HORN BUTTON ASSEMBLY
6. REMOVE STEERING WHEEL ASSEMBLY




7. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY
a. Remove the 3 screws.




b. Reverse the steering wheel and remove the 3 screws.
c. Remove the steering wheel boss cover lower and switch.

8. INSPECT STEERING WHEEL CENTER POINT
9. INSTALL STEERING WHEEL ASSEMBLY
10. INSPECT HORN BUTTON ASSEMBLY
11. INSTALL HORN BUTTON ASSEMBLY
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. PERFORM INITIALIZATION

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

14. CHECK SRS WARNING LAMP