Drive Belt: Service and Repair
FAN AND GENERATOR V BELTREPLACEMENT
1. REMOVE AIR CLEANER INLET NO.1
2. REMOVE FAN AND GENERATOR V BELT
a. Loosen the belt tension by turning the belt tensioner counterclockwise, and remove the V belt.
HINT: The tension pulley has a left-hand thread.
3. INSTALL FAN AND GENERATOR V BELT
a. Set the V belt to everything except the idler pulley No. 2, as shown in the illustration.
b. Loosen the V belt by turning the belt tensioner counterclockwise.
c. Then set the V belt to the idler pulley.
d. After a new belt has been installed, check that the mark is within the A range shown in the illustration.
4. INSTALL AIR CLEANER INLET NO.1