Engine Mount Control Solenoid: Service and Repair

Acceleration Sensor:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE ENGINE UNDER COVER LH
3. REMOVE ENGINE UNDER COVER RH
4. REMOVE COOL AIR INTAKE DUCT SEAL
5. REMOVE ENGINE ROOM SIDE COVER LH
6. REMOVE V-BANK COVER SUB-ASSEMBLY
7. REMOVE AIR CLEANER INLET ASSEMBLY
8. REMOVE NO. 1 AIR CLEANER INLET
9. REMOVE ACCELERATION SENSOR




a. Disconnect the acceleration sensor connector and clamp.




b. Remove the 2 nuts and acceleration sensor.

INSTALLATION

1. INSTALL ACCELERATION SENSOR




a. Install the acceleration sensor with the 2 nuts.

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)




b. Connect the acceleration sensor connector and clamp.

2. INSTALL NO. 1 AIR CLEANER INLET
3. INSTALL AIR CLEANER INLET ASSEMBLY
4. INSTALL V-BANK COVER SUB-ASSEMBLY
5. INSTALL ENGINE ROOM SIDE COVER LH
6. INSTALL COOL AIR INTAKE DUCT SEAL
7. INSTALL ENGINE UNDER COVER RH
8. INSTALL ENGINE UNDER COVER LH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION
a. Perform initialization procedure.

NOTE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.