Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor:

REMOVAL

1. REMOVE GENERATOR ASSEMBLY
2. DISCONNECT COOLER COMPRESSOR ASSEMBLY
3. REMOVE CRANKSHAFT POSITION SENSOR

a. Disconnect the crankshaft position sensor connector.
b. Remove the bolt and crankshaft position sensor.

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

b. Install the crankshaft position sensor with the bolt.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

c. Connect the crankshaft position sensor connector.

2. INSTALL COOLER COMPRESSOR ASSEMBLY
3. INSTALL GENERATOR ASSEMBLY