Heated Oxygen Sensor

Heated Oxygen Sensor:

REMOVAL

1. REMOVE ENGINE UNDER COVER LH
2. REMOVE ENGINE UNDER COVER RH
3. REMOVE EXHAUST PIPE NO. 1 SUPPORT BRACKET
4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
5. REMOVE HEATED OXYGEN SENSOR (for Bank 1)

a. Using SST, remove the oxygen sensor.

SST 09224-00010

6. REMOVE HEATED OXYGEN SENSOR (for Bank 2)

a. Using SST, remove the oxygen sensor.

SST 09224-00010

INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR (for Bank 2)

a. Using SST, install the heated oxygen sensor.

SST 09224-00010

Torque: 44 N.m (449 kgf.cm, 32 ft.lbf)

NOTE: The torque shown should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST.

2. INSTALL HEATED OXYGEN SENSOR (for Bank 1)