Variable Valve Timing Actuator Position Sensor: Service and Repair

VVT Sensor:

REMOVAL

1. REMOVE ENGINE UNDER COVER LH
2. REMOVE ENGINE UNDER COVER RH
3. DRAIN ENGINE COOLANT
4. REMOVE COOL AIR INTAKE DUCT SEAL
5. REMOVE ENGINE ROOM SIDE COVER LH
6. REMOVE ENGINE ROOM SIDE COVER RH
7. REMOVE V-BANK COVER SUB-ASSEMBLY
8. REMOVE AIR CLEANER INLET ASSEMBLY
9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
11. REMOVE NO. 1 AIR CLEANER INLET
12. REMOVE FRONT SUSPENSION UPPER CENTER BRACE
13. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
14. REMOVE VVT SENSOR (for Bank 1 Intake Side)

a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.

15. REMOVE VVT SENSOR (for Bank 1 Exhaust Side)

a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.

16. REMOVE VVT SENSOR (for Bank 2 Intake Side)

a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.

17. REMOVE VVT SENSOR (for Bank 2 Exhaust Side)

a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.

INSTALLATION

1. INSTALL VVT SENSOR (for Bank 2 Exhaust Side)

a. Install the VVT sensor with the bolt.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

b. Connect the VVT sensor connector.

2. INSTALL VVT SENSOR (for Bank 2 Intake Side)

a. Install the VVT sensor with the bolt.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

b. Connect the VVT sensor connector.

3. INSTALL VVT SENSOR (for Bank 1 Exhaust Side)

a. Install the VVT sensor with the bolt.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

b. Connect the VVT sensor connector.

4. INSTALL VVT SENSOR (for Bank 1 Intake Side)

a. Install the VVT sensor with the bolt.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

b. Connect the VVT sensor connector.

5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
6. INSTALL NO. 1 AIR CLEANER INLET
7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
9. INSTALL AIR CLEANER INLET ASSEMBLY
10. INSTALL V-BANK COVER SUB-ASSEMBLY
11. ADD ENGINE COOLANT
12. CHECK FOR ENGINE COOLANT LEAKS
13. INSTALL FRONT SUSPENSION UPPER CENTER BRACE
14. INSTALL ENGINE ROOM SIDE COVER LH
15. INSTALL ENGINE ROOM SIDE COVER RH
16. INSTALL COOL AIR INTAKE DUCT SEAL
17. INSTALL ENGINE UNDER COVER RH
18. INSTALL ENGINE UNDER COVER LH