Collision Avoidance Sensor: Service and Repair

Millimeter Wave Radar Sensor:

MILLIMETER WAVE RADAR SENSOR

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE FRONT BUMPER ASSEMBLY

4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY




a. Disconnect the connector.
b. Remove the 3 bolts and the millimeter wave radar sensor assembly.

INSTALLATION

1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY




a. Install the millimeter wave radar sensor assembly with the 3 bolts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

b. Connect the connector.

2. INSTALL FRONT BUMPER ASSEMBLY
3. INSTALL COOL AIR INTAKE DUCT SEAL
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. ADJUST MILLIMETER WAVE RADAR SENSOR

6. PERFORM INITIALIZATION Testing and Inspection

NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

7. VEHICLE PREPARATION FOR FOG LIGHT AIM
8. PREPARATION FOR FOG LIGHT AIMING
9. FOG LIGHT AIMING INSPECTION
10. FOG LIGHT AIMING ADJUSTMENT