Acceleration/Deceleration Sensor: Service and Repair

Yaw Rate And Acceleration Sensor:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY WITH FRONT ASH RECEPTACLE
4. REMOVE INSTRUMENT PANEL FINISH END PANEL LH
5. REMOVE INSTRUMENT PANEL FINISH END PANEL RH
6. REMOVE CONSOLE POCKET
7. REMOVE CONSOLE BOX CARPET
8. REMOVE CONSOLE REAR END PANEL SUBASSEMBLY
9. REMOVE REAR CONSOLE BOX ASSEMBLY
10. REMOVE NO. 3 CONSOLE BOX DUCT
11. REMOVE YAW RATE AND ACCELERATION SENSOR




a. Disconnect the yaw rate sensor connector and clamp.
b. Remove the 2 bolts and yaw rate sensor.

NOTE: Do not remove the sensor from the bracket.

INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR




a. Install the yaw rate and acceleration sensor with the 2 bolts.

Torque: 13 N.m (133 kgf.cm, 10 ft.lbf)

NOTE:
- Do not damage the yaw rate and acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.

b. Connect the yaw rate and acceleration sensor connector and clamp.

2. INSTALL NO. 3 CONSOLE BOX DUCT
3. INSTALL REAR CONSOLE BOX ASSEMBLY
4. INSTALL CONSOLE REAR END PANEL SUBASSEMBLY
5. INSTALL CONSOLE BOX CARPET
6. INSTALL CONSOLE POCKET
7. INSTALL INSTRUMENT PANEL FINISH END PANEL LH
8. INSTALL INSTRUMENT PANEL FINISH END PANEL RH
9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY WITH FRONT ASH RECEPTACLE
10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
11. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
12. INSPECT SENSOR SIGNAL