Front Speed Sensor

Front Speed Sensor:

REMOVAL

HINT:
- Use the same procedure for the RH side and LH side.
- The procedures listed are for the LH side.

1. REMOVE FRONT WHEEL
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
3. REMOVE FRONT FENDER LINER
4. REMOVE FRONT SPEED SENSOR




a. Disconnect the front speed sensor connector and clamp.




b. Remove the 2 bolts from the body and the shock absorber assembly.
c. Disengage the 2 claws from the steering knuckle and body.




d. Remove the bolt and the front speed sensor.

NOTE:
- Prevent foreign matter from attaching to the sensor tip.
- Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.

INSTALLATION

1. INSTALL FRONT SPEED SENSOR




a. Install the front speed sensor with the bolt.

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

NOTE: Prevent foreign matter from attaching to the sensor tip.




b. Install the front speed sensor with the 2 bolts and engage the 2 claws.

Torque:
Bolt A 5.0 N.m (51 kgf.cm, 44 in.lbf)
Bolt B 19 N.m (194 kgf.cm, 14 ft.lbf)

NOTE:
- Do not twist the wire harness for the front speed sensor when installing the speed sensor.
- The bolt B tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.
- Install the stopper firmly to the hole in the body.




c. Connect the front speed sensor connector and engage the clamp.

2. INSTALL FRONT FENDER LINER
3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
4. INSTALL FRONT WHEEL

Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)

5. CHECK SPEED SENSOR SIGNAL