Skid Control Sensor
Skid Control Sensor:
REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedures listed are for the LH side.
1. REMOVE REAR WHEEL
2. DISCONNECT SKID CONTROL SENSOR WIRE
a. Disconnect the connector from the skid control sensor.
NOTE: Be careful not to damage the skid control speed sensor.
3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY
4. REMOVE REAR DISC
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR
6. REMOVE SKID CONTROL SENSOR
a. Mount the rear axle hub and bearing assembly in a vise using aluminum plates.
NOTE: Replace the rear axle hub and bearing assembly if it is dropped or receives a strong shock.
b. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
SST 09520-00031 (09521-00010, 09520-00040), 09521-00020
c. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub and bearing assembly.
SST 09520-00031 (09521-00010, 09520-00040), 09521-00020, 09950-00020
NOTE:
- Keep the skid control sensor away from magnets.
- Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
- If the skid control speed sensor rotor is damaged or deformed, replace the rear axle hub and bearing assembly.
- Do not scratch the contact surface between rear axle hub and bearing assembly and the skid control sensor.
- Do not attach foreign matter to the skid control speed sensor rotor and tip.
INSTALLATION
1. INSTALL SKID CONTROL SENSOR
a. Clean the contact surface between the axle hub and a new skid control sensor.
NOTE: Prevent foreign matter from attaching to the sensor rotor.
b. Place the skid control sensor on the axle hub so that the connector is positioned as shown in the illustration.
c. Using SST, a press, 2 V-blocks, and 2 steel plates, install the skid control sensor to the axle hub.
SST 09309-36010, 09213-58013
NOTE:
- Keep the sensor away from magnets.
- Do not use a hammer on the skid control sensor.
- Check that there is no foreign matter such as iron chips on the detecting portion of the skid control sensor.
- Slowly press the skid control sensor straight.
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR
3. INSPECT REAR AXLE HUB BEARING LOOSENESS
4. INSPECT REAR AXLE HUB RUNOUT
5. INSTALL REAR DISC
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
7. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the connector to the skid control sensor.
8. INSTALL REAR WHEEL
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
10. CHECK SPEED SENSOR SIGNAL